NOTICE: This version of the NSF Unidata web site (archive.unidata.ucar.edu) is no longer being updated.
Current content can be found at unidata.ucar.edu.
To learn about what's going on, see About the Archive Site.
NOTICE: This version of the NSF Unidata web site (archive.unidata.ucar.edu) is no longer being updated.
Current content can be found at unidata.ucar.edu.
To learn about what's going on, see About the Archive Site.
NOTE: The decoders mailing list is no longer active. The list archives are made available for historical reasons.
On Mon, 21 Nov 2005, Mark Seefeldt wrote: > Robb, > > Thank you for the NetCDF decoder pqact entries. I am currently not > producing any of the output files. > > Information: > -LDM 6.4.3 on a Red Hat Enterprise Linux v.4 > -installed: > netcdf-3.6.0-p1 > netcdf-perl-1.2.3 > udunits-1.12.4 > decoders-4.0.0 > -I placed the pqact entries into a separate pqact file named > pqact.netcdf. This file is attached. > -The pqact.netcdf file is then called from ldmd.conf with the following: > exec "pqact etc/pqact.netcdf" > -When I do a process listing I see: > ldm 7584 7580 0 Nov18 ? 00:12:38 pqact etc/pqact.netcdf > > Are there any log files or other places where I can start looking to > find out why none of the netcdf files are being produced? Mark, the first place to look is the ~ldm/logs/ldmd.log file, the pqact will send it errors to it. one can track the error by looking at the PID of the pqact etc/pqact.netcdf process. also check the pqact.netcdf that there are tabs not spaces between entry parts because spaces could be part of pattern action. ie. DDS|IDS<tab here>^S(A....|P....|XUS8.) .... ([0-3][0-9]) <tab here>PIPE<tab here>decoders/metar2nc.new1 <tab here>etc/metar.cdl.new1 <tab here>data/pub/decoded/netcdf/surface/metar make sure all the decoder table files and cdl files are in the ~ldm/etc directory. they are located in the ~/etc directory in the build location. from the ldm home directory, run the decoder from command line, ie % decoders/metar2nc.new1 etc/metar.cdl.new1 data/pub/decoded/netcdf/surface/metar < <raw data file> above is on one line robb... > > Thanks > > Mark Seefeldt > > Robb Kambic wrote: > > On Thu, 17 Nov 2005, Unidata Support wrote: > > > >> Robb, > >> > >> See second paragraph for request of pqact entries for NC decoders 4.0.0. > >> > >> ------- Forwarded Message > >> > >>> To: Unidata Support <support@xxxxxxxxxxxxxxxx> > >>> From: Mark Seefeldt <mark.seefeldt@xxxxxxxxxxxx> > >>> Subject: NetCDF decoder pqact entries > >>> Organization: UCAR/Unidata > >>> Keywords: 200511172016.jAHKGG7s010277 > >> I am currently running LDM 6.4.3. I have also intalled GEMPAK 5.8.3a. > >> I used the gen_pqact.csh script to create a pqact file to create the > >> GEMPAK files. All appears to be working very well with that. > >> > >> I have recently installed the NetCDF Decoders 4.0.0 (along with the > >> necessary netCDF, UDUNITS, and Perl-netCDF packages. I would now like > >> to create a pqact file/entries for the netCDF files. I have discovered > >> the file gribtonc.entries which appears to have the necessary entries > >> for the GRIB files. Is this correct? Other than making changes for the > >> local filesystem, is there anything else that I need to do to implement > >> these pqact entries? Are there any similar sample entries for the > >> non-GRIB products? > > > > > > Mark, > > > > the documentation was sent out with the release, maybe i should include it > > some where on the web page. i'll attach the list of pqact actions for > > both the text bulletions and the model files. > > > > robb... > > > > > > > >> If there is a document already present to answer these questions, feel > >> free to point me that direction. I was not able to find any in my search. > >> > >> Thanks > >> > >> Mark > >> > >> -- > >> NOTE: All email exchanges with Unidata User Support are recorded in the > >> Unidata inquiry tracking system and then made publicly available > >> through the web. If you do not want to have your interactions made > >> available in this way, you must let us know in each email you send to us. > >> > >> ------- End of Forwarded Message > >> > > > > ============================================================================== > > Robb Kambic Unidata Program Center > > Software Engineer III Univ. Corp for Atmospheric > > Research > > rkambic@xxxxxxxxxxxxxxxx WWW: http://www.unidata.ucar.edu/ > > ============================================================================== > > > > > > ------------------------------------------------------------------------ > > > > # > > # surface data in netCDF format > > # > > # metar decoder, creates NetCDF files formated > > Surface_METAR_yyyymmdd_hh00.nc > > # All aviation reports including metar tests. old netcdf file format > > DDS|IDS ^S(A....|P....|XUS8.) .... ([0-3][0-9]) > > PIPE decoders/metar2nc > > etc/metar.cdl > > data/pub/decoded/netcdf/surface/metarold > > # > > # metar decoder, creates NetCDF files with new CDL format on a daily basis > > # formated data/decoded/yyyymmdd_metar.nc > > DDS|IDS ^S(A....|P....|XUS8.) .... ([0-3][0-9]) > > PIPE decoders/metar2nc.new1 > > etc/metar.cdl.new1 > > data/pub/decoded/netcdf/surface/metar > > # > > # upper air perl decoder > > DDS|IDS ^U[ABDEFGHIJKLMPQRSTXZ].... .... ([0-3][0-9]) > > PIPE decoders/ua2nc > > etc/raob.cdl > > data/pub/decoded/netcdf/upperair > > # > > # buoy reports in yymmddhh_buoy.nc decoded into NetCDF format > > DDS|IDS ^S[NS].... .... ([0-3][0-9]) > > PIPE decoders/buoy2nc > > etc/buoy.cdl > > data/pub/decoded/netcdf/surface/buoy > > # > > # Synoptic reports in yymmddhh_syn.nc decoded into NetCDF format > > DDS|IDS ^SM.... .... ([0-3][0-9]) > > PIPE decoders/syn2nc > > etc/syn.cdl > > data/pub/decoded/netcdf/surface/synoptic > > # > > # grid data in netCDF format > > # > > # GFS grid on Lambert conformal CONUS grid replacing avn-q > > HRS ^Y.Q... KWB. (..)(..).*/m(AVN|SSIAVN|GFS|SSIGFS) > > PIPE decoders/gribtonc > > etc/gfs_211.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/GFS/CONUS_80km/GFS_CONUS_80km_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # GFS grid on thinned grids, interpolated to global 5.0 x 2.5 regular grid > > HRS ^H.[I-P]... KWB. (..)(..).*/m(AVN|SSIAVN|GFS|SSIGFS) > > PIPE decoders/gribtonc > > -q "lin,dlat=2.5,dlon=5.0" etc/gfs_37-44.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/GFS/Global_5x2p5deg/GFS_Global_5x2p5deg_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # ECMWF grid on global 2.5 x 2.5 degree grid > > HRS ^H.[A-L]... ECMF (..)(..) > > PIPE decoders/gribtonc > > etc/ecmwf_1-12.cdl > > > > data/pub/decoded/netcdf/grid/ECMWF/Global_2p5/ECMWF_Global_2p5_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # ETA grid on Lambert conformal CONUS grid > > HRS ^Y.Q... KWB. (..)(..).*/m(ETA|NAM) > > PIPE decoders/gribtonc > > etc/eta_211.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/NAM/CONUS_80km/NAM_CONUS_80km_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # GFS grid on global 5.0 x 5.0 degree grid > > HRS ^H.[EF]... KWB. (..)(..) > > PIPE decoders/gribtonc > > etc/gfs_25-26.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/GFS/Extended_Global_5p0deg/GFS_Extended_Global_5p0deg_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # NGM grid on Lambert conformal CONUS grid > > #HRS ^Y.Q... KWB. (..)(..).*/mNGM > > # PIPE decoders/gribtonc > > # etc/ngm_211.cdl > > # > > data/pub/decoded/netcdf/grid/NCEP/NGM/CONUS_80km/NGM_CONUS_80km_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # NOW and PWAV grids on global 5.0 x 2.5 degree grids > > HRS ^H.[A-D]... .... (..)(..).*(/mNOW|/mPWAV) > > PIPE decoders/gribtonc > > etc/ocean_21-24.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/OCEAN/Global_5x2p5deg/OCEAN_Global_5x2p5deg_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # RUC grid on Lambert conformal CONUS grid > > HRS ^[YZ].Q... KWB. (..)(..).*/mRUC > > PIPE decoders/gribtonc > > etc/ruc_211.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/RUC/CONUS_80km/RUC_CONUS_80km_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # RUC2 grid on Lambert conformal CONUS grid > > HRS ^Y.W... KWB. (..)(..).*/mRUC2 > > PIPE decoders/gribtonc > > etc/ruc2_236.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/RUC2/CONUS_40km/RUC2_CONUS_40km_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # SST grid on global 5.0 x 2.5 degree grids > > HRS ^H.[A-D]... .... (..)(..).*/mSST > > PIPE decoders/gribtonc > > etc/sst_21-24.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/SST/Global_5x2p5deg/SST_Global_5x2p5deg_(\1:yyyy)(\1:mm)\1_\200.nc > > # > > # SST grid on global 2.0 x 2.0 degree grid > > HRS ^H.[T-W]... .... (..)(..).*/mSST > > PIPE decoders/gribtonc > > etc/sst_61-64.cdl > > > > data/pub/decoded/netcdf/grid/NCEP/SST/Global_2x2deg/SST_Global_2x2deg_(\1:yyyy)(\1:mm)\1_\200.nc > > # > ============================================================================== Robb Kambic Unidata Program Center Software Engineer III Univ. Corp for Atmospheric Research rkambic@xxxxxxxxxxxxxxxx WWW: http://www.unidata.ucar.edu/ ==============================================================================
decoders archives: