NOTICE: This version of the NSF Unidata web site (archive.unidata.ucar.edu) is no longer being updated.
Current content can be found at unidata.ucar.edu.
To learn about what's going on, see About the Archive Site.
gerry Jenkins, Mack wrote:
Thanks Daryl, My issue was much more basic. After adding my feed data to ldmd.conf, I did not restart the LDM service. Now I am getting the feed info.Thanks again guys.Mack ----- Original Message ----- From: "daryl herzmann" <akrherz@xxxxxxxxxxx> To: "Mack Jenkins" <mack.jenkins@xxxxxxxxxxxxxx> Cc: ldm-users@xxxxxxxxxxxxxxxx Sent: Friday, September 24, 2010 10:14:25 AM GMT -05:00 US/Canada Eastern Subject: Re: [ldm-users] Feed Data Question On Fri, 24 Sep 2010, Jenkins, Mack wrote:So, I have LDM and GEMPAK installed, and followed the instructions I found on the website. I have also gotten access to the data feeds that are needed for my setup. The issue I am having is that when I run "ldmadmin watch" I do not see any info. It is working on an older system that was set up a while ago by someone else, so I know what the output should look like.Just wondering if anyone can give me a suggestion and point me in the right direction?A couple of ideas: 1) Check that you have data request entries in your ldmd.conf file. 2) Check the ldm log files to see if any errors about not being able to connect or some other errors appear. 3) Are you running the latest version of LDM and is your system clock correct? 4) You can use the notifyme command to see if your upstream host is getting data. You can use the same pattern you used in the ldmd.conf file. For example: notifyme -v -l - -p ".*" -f WMO -h idd.unidata.ucar.edu Good luck, daryl
-- Gerry Creager -- gerry.creager@xxxxxxxx Texas Mesonet -- AATLT, Texas A&M University Cell: 979.229.5301 Office: 979.458.4020 FAX: 979.862.3983 Office: 1700 Research Parkway Ste 160, TAMU, College Station, TX 77843
ldm-users
archives: