Greetings,
This is a correction to the previous announcement about the netCDF operator
package.
In the announcement, I wrote:
3. If you haven't installed the latest versions of the above-
mentioned, prerequisite packages, then you can build and install
them and this package (and every other Unidata package you
have!) in one step:
% gmake udposix/all udposix/install \
udape/all udape/install \
ncopers/all ncopers/install >& log &
% tail -f log
Instead, the above commands should have been
% gmake >& log &
% tail -f log
Note that the above command will (re)build and (re)install every UPC package
you have.
Regards,
support@xxxxxxxxxxxxxxxx
