NOTICE: This version of the NSF Unidata web site (archive.unidata.ucar.edu) is no longer being updated.
Current content can be found at unidata.ucar.edu.
To learn about what's going on, see About the Archive Site.
NOTICE: This version of the NSF Unidata web site (archive.unidata.ucar.edu) is no longer being updated.
Current content can be found at unidata.ucar.edu.
To learn about what's going on, see About the Archive Site.
Hi Matthew- > Full Name: Matthew Bedard > Email Address: address@hidden > Organization: Plymouth State University > Package Version: 5.11.4 > Operating System: MacOS 10.6.1 > Hardware: Intel Mac Mini > Description of problem: I have attached my make.out file (zipped) as well as > the exact steps that I took to get compile. I have run out of ideas and I > just can't get it to work. I have read through and based my install off Ryan > Jewel's correspondence in the archives: > http://www.unidata.ucar.edu/mailing_lists/archives/gembud/2009/msg00054.html I'll look into this further next week, but in your make.out I see: ld: warning: in nalarm.o, file is not of required architecture Is it possible that you compiled once without changing MTMACH and then didn't do a make distclean before compiling again? Don Murray > I'm am not sure what the problem is but the end of the make.out file is: > > ld: symbol(s) not found > collect2: ld returned 1 exit status > make[2]: *** [dcshef_comet] Error 1 > > Perhaps someone can take a look at my instructions and my make.out file and > figure out what I am doing wrong. > > Thank you! > > Ticket Details =================== Ticket ID: DGZ-411403 Department: Support GEMPAK Priority: Normal Status: Open